NEW Instructions

Instructions:


--Heat Press Settings: Temperature: 350*F, Pressure: Medium, Time: 7 Seconds (this will vary based on heat press)

  1. Preheat Platen: Prior to beginning, press empty pad for 3 cycles of 15 seconds.
  2. Load Garment: Make sure shirt is flat on platen, no wrinkles.
  3. Pre-press garment for 5-10 seconds
  4. Position Transfer: Place transfer in desired location, ink side down. DO NOT COVER WITH TEFLON SHEET, or any other sheet! Do not place transfer on wrinkles, seams, or creases.
  5. Press Transfer: Close heat press for 7-10 seconds. (Can vary based on press)
  6. Wait 5-10 Seconds then Peel transfer with a smooth steady motion.

** We recommend Pressing design AGAIN with a Teflon sheet or parchment paper to ensure the design will stay in place**


Trouble Shooting:

Problem: Transfer not sticking evenly on shirt:

Solutions: a. Increase pressure

  1. Increase Temperature slightly
  2. Wait 10-15 seconds before peeling transfer. d. Verify platen has been pre-heated.
  3. Increase time.

Washing Instructions:

 -Machine wash, Cold, turn garment inside out.

 - Do not Bleach

 -Tumble dry, low heat,

 -Do not iron.